A test Item

Description

5" Inch K Style Aluminum Gutter Hanger w/ Clip  and integrated screw
Creates a strong durable installation that holds up to Heavy wind, rain, and snow!
??
Make sure your gutters are the right Material, Shape, and size!
??
Works ONLY with :
?
Gutters that are made of metal
?
Gutters that have the standard K or OG profile Shape
?
Gutters that measure 5 inches across the top
??
Will NOT work with:
??
Gutters that are made of plastic
??
Gutters that do not have the standard K profile shape or have a hemmed back wall(Alcoa)
??
Gutters that not 5 inches across the top
??
Features:
These hangers are delivered without oil or dirt on them, no more smudges or dirty fingerprint clean up required!
•
These hangers have a clip slides over back of gutter, notching or tucking of drip edge may be necessary in retro fits where the back wall of the gutter sits high under drip edge
•
A no clip version of this hanger is also available
•
These hangers install fast with a  1/4 inch hex head screw that is preinserted in the built in screw holder that holds the screw in place during instalation
?
Benefits:
•
These hidden hangers are complelety invisble from below the eave, no fastener head can be seen on the outside of the gutter.
• ?????
The screws stay tight and will not allow the gutter to separate from the fascia board like spikes do as wood ages over time
•
These hangers strengthen and  reenforce the shape the gutter
??
Mounting:
At least 3/4" of non dried out wood to screw into that is parallel to the building face is required
•
When fully screwed down the screw will pentrate about 1-3/8" from the back of the hanger
•
The included screw easily penetrates Aluminum or Steel Pole Barn Fascia trim, if your fascia board is less than 1-1/2" try to screw into rafter tail locations
•
The manufacuturer recomends a Minimum of 24 inch spacing in heavy snow/ice/rain load regions
?
Optional Mounting methods for Eaves that don’t have a traditonal fascia board:
•
If your fascia is angled(or your eave has only exposed angled rafter tails) you can use gutter wedges(sold seperatley) to make the back wall of the gutter vertical.
•
If your building does not have a fascia board these hangers will accept a strap(sold seperatly) that can be attached to the top of the roof
??
Tools needed to install:
• A Power drill/driver with a 1/4" Hex head bit
• Tape Measure
• Tin Snips(only if modifying drip edge)
• String line and Level(only if setting or resetting the pitch of the gutter)
??
Installation tips:
• I
f retrofitting a gutter with loosend spikes, space hangers no more than 24" apart, do not attempt to use existing spike holes
• Install the gutter in a postion or use a trim strip so that water can not get between the back of the gutter and the fascia board
• Pitch your gutter just enough so that water drains to the downspout outlet and does not pool, 1/2" per 10 feet is standard
• For gutter runs longer than 40 feet, it's best to pitch the gutter down from the middle to a downspout at each end
• Aluminum products expand and contract with tempurature, the ideal installation tempurature is 60 to 85°F or 15-30°C.
• Use a quality sealant at all seams and joints that can flex with tempurature changes
?
Formed from aluminum Recycled in the USA
© 2022 Rainware supply, all rights reserved, used with permision by Nextridge GutterHardware
Due to rampant internet drop shipping schemes, only product that is purchased from Nextridge GutterHardware can be guaranteed to meet specifications as shown.